A Error Messages

PFORM Error Messages

These error messages may occur when using PFORM:

A NUMBER -2 through 7 or 10 through 99 IS REQUIRED -- a device address outside the acceptable range was entered.

BLANK INPUT NOT ALLOWED -- a file name or device address must be entered.

CANNOT CONTINUE UNTIL AT LEAST ONE VERSION IS SELECTED -- select at least one version of the form to be printed by pressing the appropriate softkey. Then press CONTINUE.

ENHANCEMENTS/SPECIAL CHARACTERS NOT ALLOWED -- video enhancements and special characters cannot be output by most printers. Re-enter using standard characters.

FATAL ERROR xxx ENCOUNTERED xxx -- an internal error occurred in the PFORM program. Note this error and report it to your service representative.

FILE NAME IS REQUIRED -- a file name must accompany the volume specifier. To enter all forms on a volume, use the multiple forms menu.

FILE NAME TOO LONG -- the file name must be nine characters or less.

FILE NOT FOUND -- the file was not found on the volume specified. If no volume was specified, the current mass storage volume was used.

GIVEN (OR DEFAULT) VOLUME NOT MOUNTED -- a directory with the specified label was not found.

ILLEGAL PROGRAM ENTRY -- attempt to enter the PFORM program at its entry point, PFRM, and the program could not be found.

IMPROPER VOLUME NAME -- a volume name has a maximum of eight characters.

PFORM/PFRM REVISION NUMBER CONFLICT -- PFORM and PFRM do not have the same revision number.

PRINTER IS MISSING, OR WRONG TYPE, DOWN, OR OFFLINE -- check the status of the printer. RESET and switch the printer ON-LINE. Then re-enter the printer device address.

VOLUME NOT FOUND -- the volume name specified is not found.


Eloquence Forms Manual - 19 DEC 2002