2 Installing Eloquence on the HP-UX platform
r Mount the CD-ROM media.
mount /dev/dsk/c3d0s2 /cdrom
where /dev/dsk/c3d0s2 is the device file associated with the CD-ROM drive and /cdrom is the directory where the CD-ROM should be mounted. The Eloquence software for the HP-UX platform is in the A0600/hpux subdirectory.
r Start "update(1m)" by typing:
/etc/update
To install the Eloquence software, follow the directions below:
* Select "Change Source or Destination ->".
* Select "From Tape Device to Local System ...".
* Tab to the "Source" field and enter the following:
/cdrom/A0600/hpux/B1368B.UPDT;1
where /cdrom is the directory where the cdrom is mounted. Because HP-UX does not support the Rock-Ridge CD-ROM extensions, file names are upper case with a trailing ;1.
* Press "Done".
* Select "Select/View Partitions and Filesets ..."
* Activate the B1368B partition to install the Eloquence product.
* Select "Start Loading".
* Type "y" to "Start loading filesets now ?".
* Check /tmp/update.log to make sure installation completed with no error.
r Insert the Eloquence DDS tape into your tape drive and extract the software from tape to a temporary location.
cd /tmp
tar xf /dev/rmt/0m A0600/hpux/B1368B.updt
where /dev/rmt/0m is your DDS tape device file.
r Start "update(1m)" by typing:
/etc/update
To install the Eloquence software, follow the directions below:
* Select "Change Source or Destination ->".
* Select "From Tape Device to Local System ...".
* Tab to the "Source" field and enter the following:
/tmp/A0600/hpux/B1368B.updt
* Press "Done".
* Select "Select/View Partitions and Filesets ..."
* Activate the B1368B partition to install the Eloquence product.
* Select "Start Loading".
* Type "y" to "Start loading filesets now ?".
* Check /tmp/update.log to make sure installation completed with no error.
r After installation has completed you should remove the temporary file.
rm -r /tmp/A0600